60632 60632 RockSolid

Rust-Oleum Rocksolid Floors Moisture Stop

Product Code: 60632

Availability:Out of stock

Rs. 2,880.00 Rs. 2,592.00 2,592.00

RockSolid Moisture Stop permanently improves the durability of concrete by penetrating the surface, filling pores and capillaries, and creating a sub-surface barrier against the ingress of water and contaminants. Moisture Stop is suitable for interior and exterior use and is safe to use near grass and plants.

Moisture Stop is suitable for use on bare concrete and masonry surfaces. It can be used as a curing agent on newly poured concrete within 28 days. It can be applied to garage floors, driveways, patios and walkways as a concrete hardener. Do not use on asphalt. After application of RockSolid Moisture Stop, the surface may be stained, sealed or coated.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Rocksolid Floors Moisture Stop

  • Strengthens concrete for increased durability
  • For use prior to sealing
  • One time treatment Creates a moisture b
  • Protects against spalling, cracking and efflorescence
  • Zero VOC

How to Apply Rocksolid Floors Moisture Stop

Surface Preparation

Proper surface preparation is critical to achieve best results. The surface must be structurally sound and free of dirt, dust and other contaminants. Remove any oil or grease with RockSolid Heavy Duty Cleaner (sold separately). Scrub with a stiff bristle brush or broom. Rinse thoroughly with fresh water. A power washer is preferred. Repeat as necessary to completely clean and rinse. Allow to thoroughly dry.


Use only with adequate ventilation. Moisture Stop is ready to use. Do not thin. Use only when air (ambient) temperature is between 50-90°F (10-32°C) and the relative humidity is below 85%. Shake the container vigorously for 30-45 seconds. Completely saturate the surface using a low-pressure sprayer or by pouring the product directly on the floor. Spread the material around on the floor with a stiff bristle broom or squeegee to work the product into the floor. Using a hose or sprayer, mist the surface with water to keep the floor wet for 30-45 minutes. After 45 minutes, squeegee or broom the excess moisture from the surface. IMPORTANT: Wait a minimum of 2 hours, then flush the surface with water and squeegee to a surface dry condition. Failure to flush the surface will result in the appearance of efflorescence and will require the use of RockSolid Efflorescence Remover (sold separately).

Properties of Rocksolid Floors Moisture Stop

Brand Rust-Oleum Rocksolid
Manufacturer Rust-Oleum
Composition Modified Silicate
Solvents Water G
Weight 3.78 Ltr.
Volatile Organic Compounds 0 g/l
Practical Coverage New Concrete – 200 sq.ft./gal.
Old Concrete – 150 sq.ft./gal.
Dry Times at 70-80°
(21-27°C) and 50% RH
1 hour to Touch
2 hours to Foot Traffic
2 hours to Auto Traffic
Shelf Life 2 years
Flash Point >200°F (93°C)
Safety Information For additional information, see MSDS
Technical Data Sheet Click here