BuildKote is a two component, high solids Polyurea primer suitable for use with a variety of topcoats. It can also be used as a basecoat for color aggregate or color flake finishes.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of BuildKote Polyurea Floor Coating Primer - Part B
Can be applied by spray or roller at temperatures between -20-100 F and in high humidity
Fast dry coating can be top coated in 2-4 hours
Provides excellent adhesion to concrete, fiberglass, wood, epoxy, urethanes and polyurethanes
Can be applied clear or tinted with Polyurea Universal Tints
Can also be applied to vertical surfaces as a primer or stand-alone coating
How to Apply BuildKote Polyurea Floor Coating Primer - Part B
Surface Preparation
The concrete surface must be free of all dirt, grease, oil, fats, and other contamination. Remove surface contamination by cleaning with Pure Strength 3599 Industrial Cleaner/Degreaser, detergent, or other suitable cleaner. Rinse thoroughly with clean, fresh water and allowed to dry.
Application
Apply only when air, material and floor temperatures are between -20 - 120°F (-29 - 32°C). Do not apply in direct sunlight or when temperature is rising. Immediately after mixing, pour the material onto the floor in a long, 8 to 12 inch wide stripe.
Properties of BuildKote Polyurea Floor Coating Primer - Part B
Manufacturer
Rust-Oleum
Resin Type
Polyurea
Weight
11.34 Ltr.
Solids By Volume
98%
Volatile Organic Compounds
<10 g="" l="" td="">
Mixing Ratio
1:2 (Part A to Part B)
Induction Time
None required
Pot Life
20-25 minutes
Practical Coverage at Recommended DFT
80-200 sq.ft./3.78 Ltr. Coverage rate can vary depending on the texture and porosity of the concrete
Dry Times at 70-80° (21-27°C) and 50% RH
2-12 hours to Re-Coat 2-4 hours to Light Traffic 24 hours to full Traffic
