Krud Kutter Rust Remover is a proprietary formulation that penetrates into the voids of a metal surface and dissolves rust and oxidation through chemical action. Cleaning time will vary according to the severity of the rust. Medium to light rust will be dissolved in 10 minutes or less, while heavier deposits may require a second application. Rust Remover is recommended for cast iron, stainless steel, aluminium, galvanized, chrome and brass.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Krud Kutter Rust Remover Gel
- Clings longer to remove rust from vertical surfaces.
- Removes rust/oxidation from metal prior to painting.
Instructions to Use Krud Kutter Rust Remover Gel
Remove any oil, grease, or dirt from the surface to be treated. On heavy rusted surfaces, remove any loose rust particles with a wire brush. Rinse the metal with water, to break the surface tension and wash away any loose dirt. Turn sprayer to “SPRAY” position, and apply remover liberally to surface. Continue to apply the remover as needed, to keep the surface wet until the rust is dissolved. Disassemble units composed of moveable parts before applying remover. Clean parts and allow to dry before reassembling.
Dissolving Rust from Iron or Steel
Turn sprayer to “SPRAY” position, and apply remover liberally to surface. Continue to apply the remover as needed, to keep the surface wet. until the rust is dissolved. Chemical action begins at once. Cleaning time will vary according to the severity of the rust. Medium to light rust will be dissolved in 10 minutes or less, while heavier deposits may require a second application. Once the rust is dissolved, rinse with water, and wipe the surface dry. After one hour or more, the surface is ready to be painted.
Aluminium or Chrome
Apply the remover to a wet surface. Allow time to dissolve the rust, then rinse away with clean water and buff dry with a cloth.
Where the surface is unbroken, treat as suggested for aluminium. Where rust is showing at the surface, treat as for iron or steel.
Properties of Krud Kutter Rust Remover Gel
|Composition||Phosphoric Acid and other Proprietary Ingredients|
|Practical Coverage||50-75 square feet|
|Caution!||Contains phosphoric acid. Severe eye and skin irritant. In case of contact with
eyes or skin, flush with water for at least 15 minutes. If irritation persists,
seek medical attention. If swallowed, take large amounts of water. Do not
induce vomiting. Get medical attention. KEEP OUT OF REACH OF CHILDREN.
|Safety Information||For additional information, see SDS|
|Technical Data Sheet||Click here|