Rust-Oleum Automotive 2-In-1 Sandable And Filler Primer Spray Paint - Gray
Product Code: 260510
Have a question?
Rust-Oleum Filler Primer is a hi-build formula that fills in minor imperfections in the surface and improves topcoat adhesion and appearance. This product is suitable for use on metal, wood and fiberglass surfaces. Filler Primer features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
Features of 2-In-1 sandable and filler primer spray
- The hi-build formula fills in minor imperfections.
- Sands smooth for the ultimate finish.
- 2 in 1 Primer features an advanced spray system that allows you to spray at any angle
- A comfort spray tip with wider finger pad.
- Stops Rust formula.
NOTE: When dry, surface can be immediately recoated, top coated or wet sanded. For best results allow 2-4 hours before dry sanding.
How to Apply 2-In-1 Sandable And Filler Primer Spray
Suitable Environmental Conditions
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Make your surface ideal
Wash the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 12-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart. Do not use near open flame.
Properties of 2-In-1 Sandable and Filler Primer Spray
|Resin Type||Modified Alkyd|
|Pigment Type||Titanium Dioxide and Inorganic Pigments|
|Solvents||Acetone and Aromatic Hydrocarbons|
at Recommended DFT
|Fill Weight||340 Grams|
Recommended Dry Film
Thickness (DFT) Per Coat
|1.5-2.5 mils (37.5-62.5µ)|
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
|10 minutes to touch and re-coat aytime after 10 minutes|
|Dry Heat Resistance||93°C|
|Shelf Life||5 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|