Rust-Oleum Peel Coat Lens Tint is an easy, no-commitment way to customize your vehicle tail lights, fog lights and turn indicators. This translucent coating gives you lights a blackout appearance until they are lit; then the original color shows through. Lens Tint creates a finish that is durable and weather resistant. Just spray it on, keep it on and peel it off when ready.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Peel Coat Lens Tint Spray
- The coating gives your tail lights a "black out" look.
- Fan spray tip helps to apply an even finish.
- Peelable rubber coating allows you to change up your look whenever you want.
- For off road use only.
Featured Video of Rust-Oleum Peel Coat Lens Tint Spray Paint
How to Apply Rustoleum Peel Coat Lens Tint Spray Paint
Painting Conditions: Use outdoors or in a well ventilated area. Use when temperature is between 50-90°F (10-32°C) and humidity is below 65% to ensure proper drying. Do not apply to galvanized metal. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist
Surface Preparation: Removing the lens from your vehicle is recommended for ease of application. If you cannot remove the lens from your vehicle, mask the adjoining areas to protect from spray mist. Prepare the surface by removing any oil, grease, wax or road tar. Thoroughly wash the surface with soap and water prior to application. Rinse with fresh water and allow to dry. Priming is not required or recommended.
Application: Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 8-12" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Apply 2-3 light coats to build the desired film thickness, followed by one coat to achieve a smooth final film. DO NOT APPLY MORE THAN 4 COATS. Remove any tape while the last coat is still wet. Allow coating to dry to a matte finish (about 5 minutes) between coats. Allow the coating to cure for 24 hours before washing. Do not use near open flame.
Properties of Rust-Oleum Peel Coat Lens Tint Spray Paint
|Resin Type||Synthetic Rubber|
|Solvents||Blend of Aliphatic and Aromatic Solvents|
Recommended Dry Film
Thickness (DFT) Per Coat
at Recommended DFT
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
|20 min to touch. 21 hours to fully cure|
|Shelf Life||2 years|
|Flash Point||-140°F (-96°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|