Rust-Oleum Metallic Speck Spray Paint is perfect to customize cars, bikes, helmets and more. It produces speck finish which looks very unique. This rust preventive formula is suitable for indoors and outdoors. Its dry time to touch is 20 minutes and recommended recoat time is 24 hours. An Aerosol spray of convers 8 to 10 square feet of area.
An advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Metallic Speck Spray Paint:-
- Rust preventive.
- Dries quickly.
- Perfect to modify vehicles.
- Interior and exterior durability.
- Excellent coverage.
NOTE: It takes 2 days to achieve utmost durability and paint adhesion.
How to Apply Metallic Speck Spray Paint?
Appropriate Conditions to Spray
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Remove all dirt, grease, and wax with Wax & Tar Remover. Wash the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth.
Priming For Best Results
Use of a Primer Spray provides added corrosion protection on metal and promotes adhesion and hiding. A primer is especially recommended for metal and plastic surfaces. Recommended primers include 249321 primer sealer spray and any of the sandable primer spray (249419 Red, 252472 Light Gray, or 249415 Gray).
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-12" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart. Maximum adhesion is achieved in 48 hours. Do not use near open flame.
Properties of Metallic Speck Spray Paint
|Resin Type||Modified Alkyd|
|Solvents||Acetone and Aromatic Hydrocarbons|
Recommended Dry Film
Thickness (DFT) Per Coat
|1.0-2.0 mils (25-50µ)|
at Recommended DFT
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
|20 minutes to touch and re-coat after 24 hours|
|Shelf Life||5 years|
|Flash Point||-156°F (-104°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|