Rust-Oleum Peel Coat Color Shift is a specialized topcoat for use over Peel Coat Black. The Color Shift flakes contain advanced light interference pigments that change color depending on the light source. The more coats applied, the more dynamic the effect. Peel Coat is a removable rubber coating that provides endless customization for automotive and other applications. Peel Coat is suitable for use on metal, plastic and more.
NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.
Features of Peel Coat Top Coat Color Effect
- The color shift finish takes Peel Coat designs to another level.
- Color Shift showcases 3 colors simultaneously depending on the light source.
- Peelable rubber coating allows you to change up your look whenever you want.
- ***Apply Top Coats ONLY over Peel Coat Base Colors
How to Apply Peel Coat Top Coat Color Effect Spray Paint
Painting Conditions: Use outdoors or in a well ventilated area. Use when temperature is between 50-90°F (10-32°C) and humidity is below 65% to ensure proper drying. Do not apply to galvanized metal. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.
Surface Preparation: Thoroughly wash Peel Coat base coat with soap and water prior to application. Rinse with fresh water and allow to dry.
Application: Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Mask off the area to be coated. Make sure the Black Peel Coat is completely dry before top coating. Hold can 8-12" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Apply as many coats as desired. The last coat should be applied as a wet coat to ensure the coating lays smoothly on the surface.Remove any tape while the last coat is still wet. Allow coating to dry 5 minutes between coats. Allow the coating to cure for 24 hours before washing. The topcoat alone cannot be removed. The topcoat is removed with the base Peel Coat color. Do not use near open flame
Properties of Rust-Oleum Automotive Peel Coat Top Coat Color Effect
|Resin Type||Synthetic Rubber|
|Pigment Type||Varied Metallic Flakes|
|Solvents||Blend of Aliphatic and Aromatic Solvents|
Recommended Dry Film
Thickness (DFT) Per Coat
|0.5-1.0 mils (12.5-25µ)|
at Recommended DFT
Dry Times at 70-80°F
(21-27°C) and 50% Relative Humidity
|20 min to touch and 1 hour to handle|
|Shelf Life||2 years|
|Flash Point||-140°F (-96°C)|
|Safety Information||For additional information, see MSDS|
|Technical Data Sheet||Click here|